Auto Launch - Utilize your no used mobile phone

Most of today's vehicles are equipped with navigation.
However, since data communication is not possible except for some vehicles, it is possible to guide only a simple route.
However, accuracy is somewhat lower than navigation using data.

Because there is no data about the flow of the vehicle, the function can be reduced only by simple guidance.

With this app, you can use it as your desired navigation.


There are two ways to use it.


first. How to use an unused phone
There is no need to worry about it, and mobile phones that can communicate with data sharing or data sharing are also available.
You can use the car navigation system for rear camera use, and install this app on your unused mobile phone and use it for navigation purposes only.

Keep the vehicle in the desired position and connect the power cable.
(Since the power is connected, you do not have to turn off after driving.)

When the vehicle is started, the registered navigation is automatically executed when the power is connected.

Nowadays, voice support is also available, so when navigation is turned on, you do not have to type in "say where you want to go".


In addition, if you can not communicate by itself (WiFi-free terminal), if you register WiFi for "tethering (data sharing)" and register it only, this terminal is connected only to registered WiFi, It's possible to use.

** Brief usage order **
1. Fix the mobile phone to be used as a navigator in a specific location.
2. Connect the power cable.
3. Automatically run App. Selection (only one time, changeable)
4. WiFi registration to connect. (Only one time, it is possible to change)
5. Using ~
Please refer to the Capture screen for details.


second. If you use your mobile phone
This is not much different.
Just do not turn on the WiFi option, but if you select only the navigation app you want to auto-launch, the usage is the same.

After installing the power cord, start the operation.
The automatically registered navigation will be executed.

** Brief usage order **
1. Mounting on mobile phone holder
2. Connect the power cable.
3. Automatically run App. Selection (only one time, changeable)
4. Use ~~