DIY Terracotta Fountain Ideas

Although the idea of using pots as garden fountains is not a new idea, I came across a way of building them that I hadn't seen before and would like to share that with you. The idea is simple. First you will have to choose the pots you will use for your fountain. You need a basin, a base and the pot you will use as the fountain. Choose the shape of the main fountain not only for its appearance but also how it will function. Smooth pots with very little taper on the bottom will be quieter as the water will cling to sides as it falls. Some pots have ridges or rings that will cause the water to fall off producing more sound.

You start with a large sized terracotta or stone bowl as your foundation. This will be the basin pot where the overflowing water will fall. Drill a hole out of the bottom center of the bowl if there isn't one already. Now take the cord from your pump and run it through the hole. For larger holes, cover with duct tape and fill with Bondo. Smaller holes can be filled in with silicon. When that has dried, coat the inside with a water sealant. Now you should be ready to place the basin in your desired location. Although not crucial, try to make the basin as level as possible.

The base pot is a pot that is turned upside down and houses the pump. Choose a pot that has a base diameter the same as the base diameter of the main fountain pot. Soak the pot overnight in water. This helps make it easier to cut notches around the top rim of the pot. These notches allow water to come in that gets pumped up through the fountain tube.

Cut a piece of tubing about a foot longer than the height of the fountain pot. Attach this to the pump. Now feed the base pot down over the tube through the hole in the bottom of the pot. Seal the gap around the tube with more silicon. Now you should have your basin with an upside down pot sitting in the middle of it with a pump inside and the tube sticking out the top of the base pot.

Now take your fountain pot and test fit it by feeding it down over the tube and placing it on top of the base pot. If everything looks good (it should be plumb and level with the tube sticking out the top higher than the height of the pot) you can take off the fountain pot and run two thick beads of silicon around the top of the base pot. Run one bead towards the outside to help hold the pots together and one on the inside to keep water from running in between the two pots.

Once everything has dried, fill with water and test. Now you will have to adjust the height of the tubing to get the desired effect you are looking for. Finish by filling in the basin with rocks.

Whether you choose a traditional sunken pool to enhance your garden, or want to relax to the gentle sound of a water fountain at the end a stressful day, we've got some great ideas and buys to suit every outdoor space.

What you need to know

Choose the best position

If you install a feature with running water, such as a fountain, stream or waterfall, you might need a reservoir tank, so bear this in mind when choosing the best spot. Fountains and running water also need access to electricity to operate a pump, unless they are solar powered.

If you want to install a pond, it will need to be in a spot that gets at least five hours of natural light a day- preferably sunshine - for the water to remain clear for fish and plants. Avoid overhanging trees and shrubs, as fallen leaves can choke a pond and poison the water.

Take care of your feature

Ponds and water features will benefit from an annual clean. The best time to do this is in spring, which will give aquatic plants time to re-establish themselves before summer.